Hermetically Sealed, Very High Speed, Logic Gate Optocouplers
The 5962-8957104Kxx is a DLA SMD two-channel hermetically sealed optocoupler in a 20 pad leadless ceramic chip carrier and the highest reliability level (Class K). Solder dipped pads is available and the solder contains lead.
The product is capable of operation and storage over the full military temperature range and may also be purchased as either commercial grade or with full MIL-PRF-38534 Class Level H testing on the same DLA Standard Microcircit Drawing. The 5962-8957104Kxx is manufactured and tested on a MIL-PRF-38534 certified line and is included in the DLA Qualified Manufacturers List QML-38534 for Hybrid Microcircuits.
Each channel contains an AlGaAs light emitting diode which is optically coupled to an integrated high gain photon detector. This combination results in very high data rate capability. The detector has a threshold with hysteresis which typically provide 0.25 mA of differential mode noise immunity and minimizes the potential for output signal chatter. The detector in the single channel units has a three state output stage which eliminates the need for a pull-up resistor and allows for direct drive of a data bus.
All units are compatible with TTL, STTL, LSTTL, and HCMOS logic families. The 35 ns pulse width distortion specification guarantees a 10 MBd signaling rate at 125 degrees C with 35% pulse width distortion. Package styles for this die set in one or two channels are 8-Pin DIP through hole and 20 pad leadless ceramic chip carrier. Most devices may be purchased with a variety of lead forms and plating options. See the datasheet for details.
Because the same electrical die (emitters and detectors) are used for each channel of each device listed in the datasheet, absolute maximum ratings, recommended operating conditions, electrical specifications, and performance characteristics shown in the datasheet figures are virtually identical for all parts. Occasional exceptions exist due to package variations and limitations and are as noted. Additionally, the same package assembly processes and materials are used in all devices. These similarities give justification for the use of data obtained from one part to represent other parts performance for reliability and certain limited radiation test results.
- Highest reliability, two channel, 20 pad leadless ceramic chip carrier
- Performance guaranteed from -55 degC to 125 degC
- MIL-PRF-38534 Class K, QML-38534
- Dual Marked with device part number and DLA standard microcircuit drawing
- High radiation immunity
- Reliability data
- Three hermetically sealed package configurations
- Single channel device (different package)
- High speed: 40 M bit/s
- Active (totem pole) outputs
- CMR: 500 V/µs guaranteed
- 1500 Vdc withstand test voltage
- Three stage output available
- Compatible with TTL, STTL,LSTTL, and HCMOS logic families
- Military and aerospace
- High reliability systems
- Transportation, medical, and life critical systems
- Isolation of high speed logic systems
- Switching power supplies
- Isolated bus driver (networking applications)
- Ground loop elimination
- Computer-peripheral interfaces
- Pulse transformer replacement
- High speed disk drive I/O
- Digital isolation for A/D, D/A conversion
- Harsh industrial environments
|CMR (min.) (V/µs)||3000.0|
|Package||20 Terminal Hermetic LCCC|
|Product Type||Hermetic High Speed Logic Gate|
|Reliability Class||MIL-PRF-38534 Class K|
|PWD (max.)||35 ns|
|Prop Delay (tPHL) Max. (µs)||60 ns|
|IF Min. (mA)||6 mA|
|Hysteresis (mA)||0.25 mA|
|Prop Delay (tPLH) Max. (µs)||60 ns|