±30A Hall Effect Sensors

Currently Viewing:

The ACHS-712x product series is a fully integrated Hall Effect-based isolated linear current sensor device family designed for AC or DC current sensing in industrial, commercial, and communications systems. The ±30A rated ACHS-7123 consists of a precise, low-offset, linear Hall circuit with a copper conduction path located near the surface of the die. Applied current flowing through this copper conduction path generates a magnetic field that the Hall IC converts into a proportional voltage. Device accuracy is optimized through the close proximity of the magnetic signal to the differential Hall transducers.

A precise, proportional voltage is provided by the low-offset, chopper-stabilized CMOS Hall IC, which is programmed for accuracy after packaging. The output of the device has a positive slope (>VOUT(Q)) when an increasing current flows through the primary copper conduction path (from pins 1 and 2, to pins 3 and 4), which is the path used for current sampling.

The internal resistance of this conductive path is 0.7 mΩ
typical, providing low-power loss. The terminals of the
conductive path are electrically isolated from the signal leads (pins 5 through 8). This performance is delivered in a compact, surface mountable, SO-8 package that meets worldwide regulatory safety standards.


  • Wide Operating Temperature: –40ºC to 110ºC
  • Primary conductor resistance: 0.7 mΩ typ.
  • Sensing current range: ±30A
  • Output sensitivity: 66 mV/A
  • Output voltage proportional to AC or DC currents
  • Ratiometric output from supply voltage
  • Single supply operation: 5.0V
  • Low-noise analog signal path
  • Device bandwidth is set via FILTER pin:
  • 80 kHz typ. Bandwidth with 1 nF filter capacitor
  • Factory-trimmed for accuracy
  • Extremely stable output offset voltage
  • Near zero magnetic hysteresis
  • Typical total output error of ±1.5%
  • >25 kV/μs Common-Mode Transient  Immunity
  • Small footprint, low-profile SO-8 package
  • Worldwide Safety Approval: UL, CSA:

Isolation Voltage 3 kVRMS, 1 minute


  • Low-power inverter current sensing
  • Motor phase and rail current sensing
  • Solar inverters
  • Chargers and Converters
  • Switching Power Supplies

Lifecycle Status


Substance Compliance

  • RoHS6
    Fully Compliant
Specification Value
Lifecycle Active
Distrib. Inventory Yes
IEC Maximum Working Insulation Voltage Viorm (VPEAK) 567.0
RoHS6 Compliant Y
On-resistance (ohm) 0.1
Output Off-State Leakage (nA) 1000
Output Load Current (A) 2.5
Output Withstand Voltage (V) 60
Package SO8
Turn Off Time (msec) 0.03
Turn On Time (msec) 0.005
UL Insulation Rating Viso (VRMS) 3000.0